Dock Hardware | Sunbum Boats

	FEMALE OUTSIDE CORNER Has two 1/2″ welded tabs. Use with male outside corner to connect docks end to end. Each leg is 10″ L x 5″ H. Joint requires bolt set or Connector pin Set.
	MALE OUTSIDE CORNER Has one 1/2″ welded tab. Use with female outside corner to connect docks end to end. Each leg is 10″L x 5″H.
	OUTSIDE CORNER END Use this corner at ends of fingers and docks. Ideal for swim floats. Each leg is 10″L x 5″H.
	INSIDE CORNER This heavy-duty inside corner should be used with one of the outside corners. Each leg has elongated holes for easy fit-up and is 8 1/2″L x 5″H.
	FEMALE T CONNECTOR Has two welded 1/2″ tabs. Bolts to side of dock to attach fingers and ramps. 5″L x 5″H
	MALE T CONNECTOR Has one welded 1/2″ tab. Use with female T connector to attach fingers and ramps. 5″ L x 5″ H. Bolt set of Connector pin set required.
	CONNECTOR PIN SET For quick disconnect. Used to connect male and female T connectors. Galvanized 3/4″ connector pin and hitch clip pin.
	BACK UP PLATES 5″ x 5″ reinforcing plates are used to back up the single T males and females.
	WASHER PLATE Use two washer plates with each angle. Measure 1-1/2″ L x 5″ H.
	ANGLE BRACKET Use this heavy-duty angle for all cross supports. Each leg measures 2-1/2″L x 5″H.
	INSIDE CORNER W/PIPE HOLDER These heavy-duty inside corners should be used with one of the outside corners and as an internal pipe holder to give strength to the dock’s frame. Measures 8-1/2″ L x 5″H. Requires carriage bolt set for attaching. Available in either 2″ or 3″ pipe sides.
	OUTSIDE PIPE HOLDER Bolts to outside of dock. Carriage bolt set required for attaching. Use 2″ pipe to hold dock in plate.
	HEAVY DUTY ROLLER ASSEMBLY Bracket and roller bolt directly to the Deck Plate and can be added to aid up and down motion of the dock. 6″ roller turns on a 5/8″ diameter shaft. 3/8″ bracket is hot-dipped galvanized.
	INSIDE ROLLING RAMP BRACKET 5″ x 11″ x 1/4″ galvanized steel inside rolling ramp bracket includes left and right ramp brackets.

	CHAIN RETAINER Bolts to side of dock. Use weights and chains to hold dock in place. Accommodates 1/4″, 3/8″ and 1/2″ chain. Measure 5″L x 5″H.